Skip to content

Brands we repair

LG washing machine repairs

Has your LG stopped draining or spinning, or started to rumble on the spin? We carry out LG washing machine repairs at your home in Gauteng, on Inverter Direct Drive front loaders, top loaders and washer-dryers: the technician finds the fault on site and quotes before any work starts.

  • Quote before any work starts
  • R300 call-out, only if you decline the quote
  • 6-month warranty on parts and labour
On this page
  1. How LG washing machines are built
  2. Signs your LG needs a technician
  3. LG faults we repair
  4. Testing a direct drive motor
  5. LG error codes in brief
  6. Quick checks before you call
  7. Is an LG worth repairing?
  8. Looking after an LG
  9. Areas and booking

How LG washing machines are built

Most LG front loaders use LG's Inverter Direct Drive motor. Instead of a belt and pulley, the motor is built onto the back of the tub and turns the drum shaft directly. It has two main parts: the rotor, a round magnetised housing fixed to the drum shaft, and the stator, a ring of wire windings that sits inside it. A small sensor tells the control board where the rotor is and how fast it is turning, so the board can control the drum precisely.

With no drive belt to slip and no carbon brushes to wear, a direct drive motor has fewer parts that wear out, which is one reason these machines run quietly. Many LG top loaders use a Smart Inverter motor, while AI DD top loaders are direct drive, like the front loaders. AI DD machines choose a wash pattern to suit the fabrics in the drum.

We repair LG front loaders, top loaders and washer-dryers as part of our washing machine repairs service across Gauteng.

Signs your LG needs a technician

  • Not spinning: the drum turns slowly, rocks back and forth, or the cycle ends before the spin. See washing machine not spinning.
  • Won't drain: water left in the drum, often with a drain code on the display.
  • Very noisy: knocking, rumbling or grinding on spin. Our guide to a washing machine that's noisy when spinning explains the usual causes.
  • Won't start: no response from the controls, or the door locks and then nothing happens.
  • Leaking, smelling or not drying: water on the floor, a musty drum, or a washer-dryer that leaves clothes damp.

LG faults we repair

Drain and water supply faults

If an LG can't empty the drum in time, it stops and shows a drain code. The usual causes are a blocked pump filter, a kinked or blocked drain hose, or a worn drain pump. If it can't fill in time, it shows a water inlet code instead: the tap may be partly closed, the water pressure low, the small mesh filter where the inlet hose meets the machine blocked, or the inlet valve faulty. Low pressure during a water supply interruption can set it off too. Our guides to a machine that won't drain and a machine that won't fill cover the safe checks for each.

Balance problems

An unbalanced load code is most often the load itself: one heavy item, a very small load, or a machine that rocks because it isn't level. Worn shock absorbers, which steady the tub on spin, can cause it too, and so can a load of jeans or towels bunched on one side of the drum.

Door faults

A door code means the machine can't confirm the door is closed and locked. Sometimes a sock is caught in the gasket; otherwise the door lock, or the catch on the door, needs replacing. Don't force a locked door: our page on a washing machine door that won't open explains why.

Bearings and noise

A deep rumble that rises with the spin speed usually means worn drum bearings, while a scrape or tick on every turn of the drum can be something caught between the drum and the tub, such as a bra wire. Our article on the signs your washing machine bearings are worn explains what to listen for.

Washer-dryer drying faults

If an LG washer-dryer washes well but won't dry, the drying heater, the fan, the condenser or a temperature sensor is usually involved. See washer-dryer drying faults.

Testing a direct drive motor

Because a direct drive motor has no belt or brushes, its faults show up differently: the drum turns jerkily or slowly, hums without turning, or the machine stops with a motor or balance code. Before replacing anything, the technician rules out the simple things that cause the same symptoms (the load, the drain and the level of the machine). Then the rotor is checked for damage, the stator windings are tested, and the rotor position sensor and its wiring are checked.

Often the cause turns out to be something small, such as a loose connector or a damaged wire, so testing before replacing saves you money. Stators and sensors are electrical parts, and they are only tested and replaced by a technician. For more on these repairs, see how we handle front loader faults and top loader faults.

LG error codes in brief

LG codes are short letter pairs that point to a system rather than a part: OE for draining, IE for the water supply, UE for an unbalanced load and dE for the door, among others. Our LG washing machine error codes guide lists the common ones with the safe checks for each. If a code comes back after you've done those checks, the fault needs a technician.

Quick checks before you call

Some LG stoppages have simple causes. Before you book, check that:

  • the house has power and the plug point works (unplug the machine and try a lamp in the socket);
  • the tap is fully open and the inlet hose isn't kinked behind the machine;
  • the drain hose isn't squashed or pushed deep into the standpipe;
  • the child lock is off (many LG models show CL while it's on);
  • the load is a sensible size, with no single heavy item washed on its own; and
  • the machine stands level and doesn't rock when you press on its top corners.

If the earth leakage trips, or you smell burning, skip the checks: leave the machine switched off at the wall and book a technician.

Is an LG worth repairing?

Usually, yes. The decision gets harder on an older LG that needs a new tub or a main control board, because either can cost a large share of a new washer. The technician tells you plainly when that's the case. Our pages on whether to repair or replace and how a repair is priced explain what to weigh up.

Looking after an LG

  • Run Tub Clean. LG suggests running the Tub Clean programme about every 30 washes, and many models remind you on the display when it's due. Run it with the drum empty, and if you add a washing machine cleaner, use an oxygen-based one, not a chlorine-based or acidic cleaner.
  • Use low-suds detergent. Front loaders need detergent made for automatic machines. Too much foam leaves residue and can stop the machine rinsing properly.
  • Clean the drain pump filter. On many LG front loaders it is behind a small cover at the bottom front, with a drain tube beside it. Switch off at the wall and unplug first, put a tray and towels down, and expect water.
  • Dry the gasket. Wipe the door gasket after washing and leave the door ajar so the drum can dry, keeping the laundry door shut if young children or pets are about.
  • Keep loads balanced. Mix big and small items rather than washing a single heavy item on its own.

Areas and booking

We repair LG washing machines across Johannesburg, Pretoria, Centurion, Sandton, Midrand and the East Rand. Every repair is done at your home, so there's no need to move a heavy machine anywhere.

Call or WhatsApp 079 895 0496, or book an LG repair online. Send the model number from the label on the machine, a photo of any code on the display, and a few words on what it's doing. That's usually enough for the technician to know what to look at first.

ProServ is an independent repairer. We are not affiliated with, authorised or endorsed by LG. LG is a trademark of its owner and is used here only to describe the machines we repair. If your machine is still under the manufacturer's warranty, contact LG first, because outside repairs may affect that warranty.

Four simple steps

How it works

  1. Contact us

    Call or WhatsApp with your machine brand and what it is doing. A photo of the error code helps.

  2. A technician comes out

    We book a time that suits you, and on urgent call-outs we aim to arrive within 1 hour, depending on where the technician is working.

  3. Diagnose and quote

    We find the fault and give you a clear price before any work. The R300 call-out fee is only payable if you decide not to go ahead with the quote.

  4. Repair

    Most repairs are done on the spot when the part is available, and every repair carries our 6-month warranty.

Questions and answers

LG washing machine repair questions

Is the motor on my LG still under warranty?
It may be. LG South Africa advertises a 10-year warranty on the motor in its washing machines. If your LG is within that period and the fault looks like the motor, check your proof of purchase and the terms for your model, and contact LG before booking a repair.
Do you repair LG top loaders?
Yes. We repair LG top loaders, including Smart Inverter models, for faults such as lid lock problems, drain pumps, inlet valves and balance issues. The visit works the same way as for a front loader: diagnosis first, then a quote.
Can the bearings be replaced on a direct drive LG?
On many models, yes. The rotor and stator come off first, then the tub is stripped to reach the bearings and seal. Where the bearings are part of a sealed tub, the whole tub has to be replaced, and we'll tell you if that makes the repair uneconomical.
Should I keep using my LG if it knocks loudly on spin?
No. Stop the programme and switch off at the wall. A loud knock can be a loose or broken part, a worn bearing or something trapped between the drum and the tub, and carrying on can turn a small repair into a big one.
Can you repair an LG that I control with the ThinQ app?
Yes. App control doesn't change how the machine fills, washes, drains or spins, so the repairs are the same as on any LG. If the app has shown a fault notification, send us a screenshot with the model number when you book.
Why does my LG wash take longer than the time it showed at the start?
Many LG programmes sense the load and adjust the time once the wash is under way, and the machine adds time if it has to rebalance the load before spinning. A cycle that runs a little longer is normal. If the time stops counting down altogether, or the machine never reaches the spin, book a technician.

Book a technician

LG washing machine playing up?

Call or WhatsApp now and we'll book a technician to come to you. You'll get a quote before any work starts.

info@proservwashingmachinerepairs.co.za