Washing machine repair services
Washing machine servicing and maintenance
Washing machine servicing is a check-up for a machine that still works, so worn hoses, blocked filters, tired brushes and noisy bearings are found before they fail. The technician works through the machine at your home and quotes for any repair before doing it.
- Quote before any work starts
- R300 call-out, only if you decline the quote
- 6-month warranty on parts and labour
On this page
- What a typical service checks
- Front loader, top loader or washer-dryer
- What you get at the end
- How often to service a washing machine
- Servicing a second-hand machine
- Signs it's due for a check
- Hoses: small parts, big floods
- Looking after the machine between services
- Servicing for landlords, guesthouses and Airbnbs
- Booking a service
What a typical service checks
A thorough service works through the machine from the water supply to the drain. On a typical visit, the technician:
- Inspects the inlet hoses and tap connections for cracks, bulges and perished washers, and clears the inlet filters so the machine fills at full speed.
- Cleans the detergent drawer and its housing, where residue and mould build up out of sight.
- Checks the door seal on a front loader for splits, mould and trapped objects, or the lid, tub rim and lint filter on a top loader.
- Checks the door lock, hinges and catch so the door closes and locks cleanly.
- Turns and lifts the drum by hand to feel for the roughness or play that points to worn bearings.
- Cleans the pump filter and checks the drain hose, its height and the standpipe.
- Looks inside the cabinet, with the machine switched off and unplugged, at the internal hoses and clips, the belt, the shock absorbers and springs, the carbon brushes on brushed motors, and any sign of leaks, rust or heat damage to the wiring.
- Re-levels the machine and tightens the lock nuts on the feet.
- Runs a test cycle to check filling, heating, draining and a full-speed spin, listening for noise and watching for leaks.
Front loader, top loader or washer-dryer
The core of a service is the same for every machine, but the focus shifts with the design. On a front loader, the door seal, the pump filter and the bearings get the closest look, because they take the most punishment from detergent residue, small objects and fast spins.
On a top loader, the suspension rods, the lid switch and the drive get extra attention, along with the lint filter in the basket if your model has one. On a washer-dryer, the drying side is checked as well: the condenser and air duct for lint, the condensing water, and a short drying run to confirm the heater and fan are working. If the drying has already started to fail, see washer dryer repairs.
What you get at the end
A service ends with a plain-language rundown of the machine's condition: what's fine, what's wearing, and what's likely to need attention in the months ahead. If something is close to failing, the technician shows you and quotes for the repair, and you decide whether to go ahead then, later or not at all.
Wear parts found on a service are often simpler to deal with before they fail. A carbon brush that's nearly worn down is an easier job than a motor damaged by a brush that wore right through, and a split door seal is better caught before it has spent weeks leaking into the base. Our washing machine parts replacement page explains each part.
How often to service a washing machine
For most households, a service about once a year is plenty. A machine that runs more than one load a day, handles work clothes, pet bedding or sports kit, or serves a guesthouse or Airbnb benefits from a check every six months or so.
A service is also worth booking when you move into a home with a machine already in it, between tenants in a rental, or when you've bought a second-hand machine and want to know its condition.
Servicing a second-hand machine
A second-hand machine can be good value, but you rarely know how it was used or moved. A service shows what you've bought: whether the bearings have play, whether the door seal and hoses are sound, whether the brushes have much life left, and whether the pump filter is packed with someone else's coins and hair clips.
It also shows whether the machine survived the move. A front loader carried without its transit bolts can arrive with damaged suspension, and that shows up on the test spin. If the check finds a major fault, you'll know before you've spent money on smaller repairs.
Signs it's due for a check
- Cycles take longer than they used to, or stall on the same step.
- The machine smells musty even after cleaning.
- Water is slow to drain, or a little is left in the drum.
- Clothes come out with detergent marks or lint on them.
- The spin is louder, or the machine moves more than it used to.
- There are drips or damp patches under or behind the machine.
- It fills slowly even though your water pressure is normal.
If the machine has stopped working, shows an error code or leaks steadily, it needs a repair rather than a service, so start with our list of common washing machine problems. If it trips the power, switch it off at the wall and leave it off until a technician has checked it.
Hoses: small parts, big floods
The inlet hose holds water at mains pressure all day, every day, even when the machine is switched off. Rubber hoses stiffen and split as they age, and a hose that bursts while nobody is home can flood a kitchen or laundry and the rooms next to it.
That's why hoses get a careful look on every service, at both ends and along their length. A hose with bulges, cracks, stiff or faded rubber or rusty fittings is worth replacing before it fails. Some machines come with a safety inlet hose that shuts off the water if it detects a leak, but even those need checking. Turning the tap off when you go away for a few days is a good habit too.
Looking after the machine between services
| How often | What to do |
|---|---|
| Every wash | Check pockets before loading, take the washing out promptly, and leave the door and detergent drawer slightly open so the inside can dry (close the laundry door if small children or pets are about). |
| Weekly | Wipe out the door seal folds and the inside of the glass. |
| Monthly | Run an empty hot maintenance or drum-clean programme, and rinse out the detergent drawer. |
| Every few months | Clean the pump filter as the manual describes. Switch off at the wall and unplug first, and have towels and a tray ready for the water. |
| Twice a year | Look at the hoses behind the machine for bulges or cracks, and check that the machine still stands level without rocking. |
Using the right amount of detergent matters as much as any of these: more doesn't clean better, and the excess leaves residue that feeds smells. Our blog post on why washing machines smell goes into detail, and our guide to protecting a washing machine from load shedding covers power surges.
Servicing for landlords, guesthouses and Airbnbs
Machines in rentals and guest accommodation get heavy use from people who don't always treat them gently, so overloading, too much detergent and objects left in pockets take their toll faster. A regular service keeps them running between guests, and a check between tenants shows whether anything needs sorting out before the next one moves in. If there are several machines at one address, say so when you book so the visit can be planned around them.
Booking a service
A service is quoted before work starts, like every job, and any parts it turns up are quoted separately and only fitted if you agree. The call-out fee is R300, only payable if you decide not to go ahead with the quote. You can book a washing machine service with a call, a WhatsApp message or the contact form. If the service turns up a repair, our washing machine repair cost page sets out what goes into its price.
Four simple steps
How it works
-
Contact us
Call or WhatsApp with your machine brand and what it is doing. A photo of the error code helps.
-
A technician comes out
We book a time that suits you, and on urgent call-outs we aim to arrive within 1 hour, depending on where the technician is working.
-
Diagnose and quote
We find the fault and give you a clear price before any work. The R300 call-out fee is only payable if you decide not to go ahead with the quote.
-
Repair
Most repairs are done on the spot when the part is available, and every repair carries our 6-month warranty.
More services
Other services
- Front loader repairs Bearings, pumps, door locks, seals, brushes and control boards on front loading machines.
- Top loader repairs Lid switches, belts, clutches, gearboxes, pumps and suspension on top loading machines.
- Washer-dryer repairs Drying heaters, fans, condensers and sensors, plus the washing faults, on combo machines.
- Installation and plumbing-in New or moved machines connected, levelled, transit bolts removed and tested.
- Parts replacement Pumps, motors, bearings, door seals, boards, heating elements and more, fitted at your home.
Questions and answers
Servicing and maintenance: questions we get asked
Is servicing worth it on a new machine?
How long does a service take?
Which maintenance jobs can I do myself?
What's the difference between a service and a repair?
Will a service stop my machine breaking down?
Does a service clean the inside of the drum?
Can a service fix a smelly washing machine?
Is a service worth it on an older machine?
Book a technician
Washing machine broken? Let's get it fixed.
Call or WhatsApp now and we'll book a technician to come to you. You'll get a quote before any work starts.