Skip to content

Blog

Why does my washing machine smell? Causes and how to fix it

By ProServ

Illustration of an open front loader door seal with a cleaning cloth and a spray bottle
On this page
  1. What the smell is telling you
  2. Where the smell starts
  3. Habits that make it worse
  4. How to get rid of the smell
  5. When the drain is the problem
  6. A routine that keeps it fresh
  7. Smells that mean a fault
  8. The bottom line

A washing machine smell is hardly ever a sign that the machine is broken. In most cases it’s a build-up problem: detergent residue, lint and stale water collecting in places you don’t see, where bacteria and mould are happy to grow. That’s good news, because you can usually clear it yourself in an afternoon.

Here’s what each smell points to, where it starts, how to clear it safely, and which smells do mean a fault.

What the smell is telling you

The kind of smell tells you where to look first.

Smell Likely cause First step
Musty, mouldy or damp Mould and residue in the door seal, the drawer or between the drum and tub Clean the seal and drawer, then run a hot empty wash
Rotten eggs or sewage Stale water by the pump, or drain air coming back into the machine Clean the pump filter, then check the drain hose set-up
Sour, like damp washing Wet laundry left in the drum, or clothes drying too slowly Unload promptly and give the machine a hot wash
Burning, hot rubber or hot plastic An electrical, motor, belt or heating fault Switch off at the wall and call a technician

Where the smell starts

A washing machine is warm, damp and dark, and every wash leaves behind detergent, softener, lint, hair and body oils for bacteria and mould to feed on. Four places collect most of it.

The door seal on a front loader

The rubber seal around the door (also called the door boot or gasket) has deep folds that hold water after every wash. Hair, lint, grit and the odd coin settle in the bottom of it, and black spots of mould or a grey slime often grow in the folds. Because it never fully dries, it’s the first place to check.

The detergent drawer and its housing

Detergent and softener don’t always rinse fully out of the drawer. What’s left turns sticky and grows mould, in the drawer and in the housing behind it, out of sight.

The drain pump filter and sump

Most front loaders hide a pump filter behind a cover low down on the front of the machine, where it traps lint, hair, buttons and coins on their way to the pump. A little water always sits behind it, and over a few months that water goes stale, which is a frequent cause of a rotten-egg smell. Top loaders collect similar debris around the pump, and many also have a lint filter inside the tub.

Between the drum and the outer tub

The drum you can see turns inside a second, outer tub. Residue builds up on the hidden outside of the drum and the inside of the tub, especially if you mostly use cold, quick or eco programmes. That’s why a machine can smell even when every part you can see looks clean. On a top loader, look under the rim of the tub and around the agitator or pulsator too.

Habits that make it worse

Modern machines and modern habits both play a part:

  • Cold and eco washes. They save electricity, but cool water doesn’t dissolve grease and detergent as well, so more residue stays behind.
  • Too much detergent. The extra doesn’t rinse away; it feeds bacteria. Front loaders use far less water than top loaders, so they need far less detergent, and it must be a low-suds type made for automatic machines. Follow the dose on the pack.
  • Only ever using liquid detergent. Many washing powders contain bleaching ingredients that help keep the inside of the machine clean. Liquids generally don’t, so if liquid is all you use, regular hot washes matter more.
  • Lots of fabric softener. Softener leaves a waxy coating inside the machine, just as it does on your towels.
  • Closing the door straight after the wash. Trapped moisture keeps the inside damp for days.

How to get rid of the smell

Safety first: switch the machine off at the wall and unplug it before you clean the door seal or the filter. Expect water to come out of the filter, so have towels and a shallow tray ready.

  1. Clean the door seal. Gently fold back the rubber and wipe out the folds with warm water and a little mild detergent, clearing out hair, grit and anything caught at the bottom. Manufacturers differ on what else is safe: some suggest a weak bleach solution for mould, while others say warm water is enough and warn that abrasive cleaners attack the rubber. Check your manual, wear gloves, and rinse and dry the seal. Never mix cleaning products: bleach gives off toxic gas with ammonia-based cleaners and with acids such as vinegar or acidic descalers, so rinse well and don’t follow a bleach clean with vinegar or a descaler.
  2. Clean the detergent drawer. Most drawers lift out when you press a release tab. Soak the drawer in warm water, scrub the corners with an old toothbrush, and wipe out the housing it slides into, including the top, where the water sprays in.
  3. Clean the drain pump filter. Follow your manual. On many machines you let the water out first through a small emergency hose beside the filter, then unscrew the filter slowly, rinse it and remove any debris. Screw it back in firmly and check for drips on the next wash.
  4. Run a hot maintenance wash. Leave the drum empty and choose the drum clean or tub clean programme if your machine has one, or the hottest cotton programme if it doesn’t. Your manual says whether to add a washing machine cleaner, a little powder detergent or nothing at all.
  5. Let it dry. Wipe the door glass and the seal dry afterwards, and leave the door and the drawer open for a few hours, with the laundry door shut if small children or pets are around.

If the smell returns within days, or a sewage smell survives the clean, look at the drain next.

When the drain is the problem

A sewage smell usually means air from the household drain is reaching the machine, especially if the sink or basin next to it smells too. Three things are worth checking:

  • Where the drain hose sits. Your manual gives the height the hose should reach and how far it should go into the standpipe. A hose pushed deep into the standpipe, sealed tightly into it or lying too low can let dirty water and drain air siphon back into the machine.
  • A dry or blocked trap. If the standpipe or a nearby basin hasn’t had water through it for a while, for example after you’ve been away, the water in its trap can dry out and let drain gases up. Running water through it may be all it needs. A slow, gurgling drain points to a partial blockage in the household plumbing, which is a job for a plumber.
  • The connection under the sink. If the hose drains into a sink waste, check that it’s tight and clear.

If you’re not sure the machine’s side of the set-up is right, our washing machine installation service can check how the drain hose is connected and set it up correctly.

A routine that keeps it fresh

Once the machine is clean, a few habits keep it that way:

  • After every wash: take the washing out promptly, wipe the door seal dry and leave the door and drawer ajar so the inside can dry. If you have small children or pets, close the laundry door instead.
  • Every week: do at least one wash at 60°C, such as towels or bedding, if the care labels allow it.
  • Every month: run a hot empty maintenance wash and rinse out the drawer.
  • Every month or two: clean the drain pump filter as the manual describes. It also helps prevent draining problems.

When it’s the clothes that smell

Sometimes the machine smells fine but clean washing comes out musty. The cause is usually what happens after the wash: laundry left wet in the drum for hours, a drum packed too tightly to rinse properly, or clothes drying slowly indoors on rainy Highveld afternoons. Hang the load as soon as the programme ends, and use the highest spin speed the fabric allows so it dries faster.

Smells that mean a fault

Most smells are build-up, but a few need a technician:

  • Burning, hot plastic or electrical smells. Switch off at the wall straight away and leave the machine unplugged. The cause could be the motor, the wiring or the heating element, or a slipping drive belt on machines that have one.
  • The earth leakage or circuit breaker trips when the machine runs. Leave it off and call a technician, because this can indicate a dangerous fault.
  • Water under the machine. A slow leak from a hose, the pump or the door seal can leave stagnant water in the base, which smells. See our guide to a washing machine leaking.
  • Water left in the drum after the cycle. A machine that doesn’t drain fully keeps stale water in the sump, and it smells within days. Our guide to a washing machine not draining covers the causes.
  • A torn seal, or mould that won’t come off. Mould that has grown into the rubber can’t be cleaned out, so the fix is a new door seal, which our washing machine parts replacement service can supply and fit.
  • A smell that keeps coming back despite regular cleaning. Heavy build-up between the drum and the tub may need a technician to open the machine and clean it.

A washing machine service includes cleaning the filter and checking the door seal, hoses and drain, so it deals with most smells at the source and catches small leaks early.

The bottom line

A smelly washing machine usually needs a clean, not a repair. Clear the seal, the drawer and the filter, run a hot empty wash, then keep it fresh with measured detergent, the odd hot wash and time to dry. If there’s burning, leaking or poor draining too, switch off at the wall (at the DB board if the plug or socket is wet) and have it checked.

Washing machine still smells, won’t drain or is leaking? Call or WhatsApp ProServ on 079 895 0496 or book a technician online. We’ll come to you, track down the cause and give you a quote before any work starts.

Questions and answers

Frequently asked questions

Can I clean my washing machine with vinegar or bicarbonate of soda?
Advice differs between manufacturers, so check your manual before you try either. Vinegar must never meet bleach, because together they give off toxic gas, so don't use it in a machine you've just cleaned with bleach. For most build-up, a hot empty wash with the cleaner or detergent your manual suggests does the job on its own.
How can I tell if I'm using too much detergent?
Look for a lot of foam in the drum, clothes that feel stiff or slippery after the rinse, white marks on dark fabrics, and a slimy coating in the drawer or the door seal. Some machines also add rinses, run longer or show a foam warning when they sense too many suds. Dose by the pack's guide for your load size and how dirty it is, and remember that concentrated detergents need less.
Why are there dark flecks on my clean washing?
They're usually flakes of the greasy residue that builds up between the drum and the outer tub, breaking loose during the wash. Cool washes and generous doses of fabric softener make it build up faster. One or two hot empty maintenance washes usually clear it, and if the flecks keep coming, the machine may need a technician to open it and clean out the build-up.
Do top loaders get smelly as well?
They can, though the build-up collects in different places: under the rim of the tub, around the agitator or pulsator, and in the lint filter on models that have one. Many top loaders have no heater, so a hot maintenance wash depends on a hot-water supply; use the tub clean programme if your model has one, with the cleaner your manual suggests. Leaving the lid up after the last wash of the day lets the tub dry, as long as no small children or pets can get to it.
Can I leave a wet load in the machine overnight?
It's better not to. Washing left damp in a closed drum for hours can turn sour, and it keeps the inside of the machine damp too. Start the wash when you'll be home and awake to hang it as soon as it finishes, and if a load does sit overnight, wash it again rather than drying the smell in.
Why do my towels smell musty even after a wash?
Towels hold more water than anything else in the load, so they're the first to turn musty when they dry slowly. Fabric softener adds to it, because it coats the fibres, makes towels less absorbent and leaves residue behind. Use little or no softener on towels, wash them hot if the care label allows, and hang them in the sun or tumble dry them straight after the wash.

Book a technician

Washing machine broken? Let's get it fixed.

Call or WhatsApp now and we'll book a technician to come to you. You'll get a quote before any work starts.

info@proservwashingmachinerepairs.co.za